The new Pulsar Accolade 2 retains all of the tried and tested features of the original Accolade LRF XP50 but has the new <40mK NETD thermal sensor.
New <40mK Thermal Sensor
By now, most thermal users are familiar with the sensor resolution of a device e.g. 384x288, and also the pixel pitch e.g. 17µm. The improvement of these new Series 2 devices concentrates on a key specification of thermal sensor technology – the NETD value.
The NETD (Noise Equivalent of Temperature Differential), expressed in millikelvins (mK) is one of the most important parameters for thermal sensors as it describes their sensitivity. The lower the NETD value, the higher the sensitivity.
In existing Helion, Trail and Accolade series models the NETD value was sub 60mK. The new <40mK sensor, exclusively manufactured by ULIS for Pulsar puts Pulsar devices at the forefront of the market with the devices all featuring a better image in conditions where there is a low-temperature difference such as during rainfall, fog or cold mornings. These environmental conditions are the most difficult for thermal imagers and this new sensor will provide a clearer image for users.
- Long detection range
- High magnification
- Incremental digital zoom
- Frost-Resistant AMOLED display
- 50Hz Refresh rate
- Focusable lens
- Dioptre control
- Variable interpupillary distance
- 8 Colour modes
- “Display Off” mode
- PiP mode
- Built-In photo & video recorder
- 16GB internal memory
- Stream Vision compatible
- User Friendly controls
- Built-In laser rangefinder (eyesafe)
- Wide operating temperature (-25°C to 50°C)
- Four observation modes (Forest, Rocks, Identification and User)
- Three calibration modes (Manual, semi-auto, auto)
- Pixel correction
- Quick-Change, rechargeable IPS5 battery pack
- MicroUSB port
- Retained lens cap
- RCC Wireless remote control
- IPS Battery charger
- Stadiametric rangefinder (Non-LRF models)/ Laser Rangefinder (LRF models)